Results 1 to 4 of 4

Thread: Need help with a few problems.

  1. #1
    Inactive Member Jmunk's Avatar
    Join Date
    November 21st, 2001
    Posts
    99
    Follows
    0
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    Question

    Lately it seems that my brake pedal is a bit soft. When you hit the brakes it feels like they slowly grab instead of being there. It maybe be me but it seems when the rpm's are high the brakes feel stiffer than at low rpm. I don't believe that the rpm would have any effect on the brake system. I was thinking it could be a few things but i am not sure. I was thinking that the drums maybe need adjusted in the rear or i was thinking that the master cyclinder maybe be goin (i hope not. I looked at the pads in the fron but there is still meat on them, could it the front rotors be gettin worn down ??? Also everynow and than when i go to hit the gas when i am crusing the car bogs for a second or so than takes off, i was thinking that the fuel filter may need changed ?

  2. #2
    Inactive Member marked001's Avatar
    Join Date
    March 4th, 2001
    Posts
    795
    Follows
    0
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    Post

    have you checked the fluid level? that'd be the first place to check...also, make sure the vacuum line is in place and not damaged.....

  3. #3
    Inactive Member EMPTY's Avatar
    Join Date
    March 29th, 2002
    Posts
    57
    Follows
    0
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    Angry

    I've had the same problem with my enging bogging like that (especially after I've coasted down a hill with the car in gear...) Haven't yet been able to determine the cause. Let me know if you get anywhere with it.

  4. #4
    Inactive Member Jmunk's Avatar
    Join Date
    November 21st, 2001
    Posts
    99
    Follows
    0
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    Post

    The fluid is full. As far as a vaccum line i was thinking that could be a problem but when i checked the master cyclinder i couldn't really see a vaccum line. I'll look for the line tomorrow. Is there only one vaccum line ? And i am guessing that it comes right off or to the master cyclinder ?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •